Quantech Authorized Contractor Program - Renewal Contractor Final Exam

The interior of the QWC3 condenser tubes can be cleaned during regular maintenance.

Suction and discharge pressure transducers measure the same range and are therefore interchangeable.

What is the best way to verify calibration of an analog input, such as suction pressure?

Common symptoms of a fouled condenser are:

A Quantech chiller will continue to run when put in Service Mode.

Resetting a chiller fault may require:

What is the proper way to check the accuracy of a temperature sensor?

It is recommended to clean the Quantech microchannel condenser coils with a pressure washer.

What is the cause of a 'No Run Permissive' fault?

When starting a chiller with a pump package, what documentation is required?

When using the QTC3 pump package with sensorless control, the drive should be configured for 'Open Loop' control.

If a QTC2 chiller with pump package is not receiving the desired flow, what should be done?

The QTC3 pump package is provided with:

A Quantech chiller equipped with a dual pump package can run both pumps in parallel.

A Quantech chiller with a dual pump package will start the standby pump if the duty pump fails to close the flow switch.

On the Quantech Chiller Start-Up Registration page, what is the SECOND input field of the registration form?

What is the Quantech homepage web address?

The Quantech IOMs are accessible on the Quantech homepage under 'Products'

It is generally recommended to blow or vacuum out the rinse water from the Quantech microchannel coils to speed drying time and prevent water pooling.

The analog input for a pressure transducer is

If an extended labor warranty is purchased, the extended labor warranty is void if the start-up, commissioning, and service work isn’t completed by either an Quantech Authorized Contractor or a JCI Branch.

ACP credentials are null and void if you leave the company that employed you when you received your ACP credentials.

The Quantech Authorized Contractor Program (ACP) certifies individuals, not the company they work for.

ACP credentials expire after 1 year, be sure to renew your credentials before they expire.

The free 1 year labor warranty will only be provided when chiller is started up by individual with current ACP credentials or the JCI Branch.

A JCI Branch or the individual with current ACP credentials must be the one to perform start-up, commissioning, and any service work on the Quantech chiller.