Illuminations eyyyy
1. Polar graph representing variation in candle power of illumination
Photometric distribution
Photometric report
Photo sensor
Photometric brightness
2. The illumination is directly proportional to the cosine of the angle made by the normal to the illuminated surface with the direction of the incident flux. The above statement is associated with
Lambert's cosine law
Planck's law
Bunsen's law of illumination
Macbeth's law of illumination
3. It is a quantitative measure of the ability of a light source to reproduce the colors of various objects faithfull in comparison with an ideal or natural light source. Also called color accuracy
Spectral power
Color rendering index
Luminous emittance
Chromatic index
4. Most affected parameter of a filament lamp due to voltage change is
Wattage
Life
Luminous efficency
Light output
5. Recommended illumination level of general office for reading
40 fc
100 fc
30 fc
70 fc
6. For indoor lawn tennis, what is the recommended level of illumination for tournaments
30 fc
10 fc
20 fc
50 fc
23. What component is necessary to ignite and lit up a preheat fluorescent luminaire?
Starter
Ballast
Capacitor
Tube holder
24. The following lighting system are HID (high intensity discharge) general groups lamp EXCEPT:
Rapid start lamp
Mercury lamp
Metal halide lamp
High pressure sodium lamp
25. The flicker effect of fluorescent lamps is more pronounce at
Lower frequencies
Higher frequencies
Lower voltage
Condenser
26, When a fluorescent lamp is to be operated on a DC which of the following additional devices must be incorporated in the circuit?
Inductance
Transformer
Resistance
Condenser
27. The purpose of coating the fluorescent tube from inside with white phosphor powder is:
To improve its life
To improve the appearance
To change the colour of light emitted to white
To increase the light radiations due to secondary emissions
28. Burning hours of incandescent lamp is about
1500
750
1800
650
36. It refers to choice of electrical systems, including planning and detailing requirements for protection, control, monitoring, coordination and interlocking electrical systems among others.
System utilization design
Practice of electrical engineering
Power plant design
Electrical system design
37. Article III contains
Sec. 3 to 6
Sec 10 to 30
Sec 10 to 20
Sec 10 to 28
38. _________ is an establishment or a system for the production and modification of electric energy
Business establishments
Industrial plant
Electric plant
Commercial establishments
39. Sec. 2 (a)(6) Art 1 of RA 7920 is _____
Consultation, investigation, valuation and management of services requiring electrical engineering knowledge
Teaching of electrical engineering professional subjects
Taking charge of sale and distribution of electrical equipment
Supervision of erection, installation, testing and commissioning of power plants
40. The E.E board chairman when the RA 7920 and code of ethics was approved
Paul Joseph E. Woo
Roy F. Gil
Gerardo V. Gaor
Rafael F. Florentino
41. In what rule does R.A 184 -- old electrical engineering law (1947) stated?
Rule 2 (e)
Rule 2(f)
Rule 2 (p)
Rule 2 (j)
42. Board of electrical engineering (BEE_ will serve his term in how many years?
3
5
2
6
43. Vacancies in the Board shall be filed by the ____ from the list of recommendees selected by the commissioner who were chosen from the list of nominees submitted by the integrated and accredited association for the unexpired term only
Commissioner
President
Board member
IIEE
44. How many years does a high school graduate need to qualify for RME?
4
3
2
5
45. On what particular section in article IV of the RA 7920 is foreign reciprocity stated?
Sec 39
Sec 40
Sec 38
Sec 37
46. Sec 17 2(a) of RA 7920: Examination and registration qualifications of applicants for Registered Electrical Engineer states that an applicant is a _____ of the country
Leader
Prefessional
Citizen
Known person
47. Under penalty clause: Any person who shall violate any of the provision of this Act shall be guilty of misdemeanor and shall, upon conviction, be sentenced to a fine:
Not more than P60,000
Not more than P20,000
Not more than P10,000
Not more than P50,000
48. Associate Electrical Engineer (Asso. EE) can apply for registration as professional Electrical Engineer (PEE) without a degree of BSEE?
True
False
Can apply
Can interview
49. FOr a person to be considered to be a member of the Board of Electrical Engineering he must at the time of appointment: be a natural born Filipino citizen and a resident of the Philippines for at least ____ consecutive years; be at least _____ yrs of age. Of proven integrity with high moral values in his personal and professional conduct; have practiced electrical engineering for a period of not less than. _____ years prior to his appointment
5, 45, 10
5, 35, 10
10, 35, 5
5, 45, 15
50. Electric Power industry Reform Act of 2001 (EPIRA) is
R.A 7832
R.A 7920
R.A 9136
R.A 8495
51. Who is the board of trustee or board member of TRANSCO?
President of Transco
President of DOE
President of DENR
Department of Finance
52. In Philippine Distribution Code of Performance Standards, which of the following does NOT belong?
Collection Standards
Safety standards
Reliability standards
System efficiency standards
53. What refers to end-users who do not have choice of a supplier of electricity
Contestable market
Captive market
Market operator
Small power utility group
54. The available generating capacity in excess of the sum of the system demand plus losses within the specified period of time?
Reserve capacity
Spinning reserve
Maximum demand
Operating margin
55. In R.A 9136 what does PSALM Mean?
Power System Assets and Liabilities Management Corporation
Power Sector Assets and Liabilities Management Corporation
Power System Assets and Liabilities Management Commission
Power Sector Assets and Liabilities Management Commissions
56. It is a distribution reliability index defined as the total duration of sustained customer power interruptions within a given period divided by the total number of customer served within the same period
SAIFI
SAIDI
MAIFI
DAIFI
57. What is the meaning of WESM
World Energy Spot Market
Wholesale Electricity Spot Market
Wholesale Energy Saving Market
World Electricity Saving Market
58. A short voltage variation is a voltage swell if the root mean square (RMS) value of the voltage increases between ____ percent and ___ of the nominal value
110,180
120,190
100,150
105,175
59. Fast start is defined as the capability of a generating unit or generating plant to start and synchronizing with Grid within ___ minute/s
15
5
10
30
60. In Philippine Distribution Code Purposes, which of the following does not belong?
To ensure quality of electric power
To specify customer's services for the protection of end users
To specify standards for the protection of personnel in the work environment
To ensure distribution system will be operated by only one distribution company
Luminous intensity is defined as
Lumen per square meter
Luminous flux per unit solid angle
Illumination per square meter
Candela per unit solid angle
The study of illumination involves
Design of lightning system
Study of lighting and wiring system
Calculation of wiring sizes for various lightning fixtures
Energy radiated continuously in the form of lightning waves is called
Luminous intensity
Lumen
Luminous flux
Illumination
The luminous flux emitted in unit solid angle by a uniform point source having a luminous intensity of 1 candela is
Lumen
Illumination
Lux
Luminance
The luminous intensity of a lamp is expressed in
Watts
Lux
Lumens
Candela
The illumination at a point of a surface is the luminous flux per unit area of the surface and its unit is
Lux
Candle power
Lumen
Candela
Polar curves of a fluorescent lamp
Shows the distribution of illumination in all directions
Shows the luminous intensity in all directions in one place around light source
Determines the efficiency of the lamps
Gives the effectiveness of the reflector used for a lamp
When the light distribution from a lamp and a fitting is non uniform, the correct value of the luminous intensity in the particular direction is
Given by inverse law
Given by sine law
Given by the average value
Taken from the polar curves
The illumination of a surface is
Directly proportional to its distance from the source
Inversely proportional to its distance from the source
Directly proportional to the square of the distance from the source
Inversely proportional to the square of the distance from the source
The illumination of a surface at any point is proportional to the ___ of the angle between the normal at that point and the direction of the luminous flux.
Sine
Tangent
Cosine
Cotangent
To use lumen method of design you must first find
Room index and the lumens
Room index and the coefficient of utilization
Light distribution from a polar curve and the coefficient of utilization
Coefficient of utilization and the room index
Maintenance factor and depreciation factor takes account of
Effect of dust, dirt and fall in light output of the lamp during its life
Depreciation in the capital cost of installation
Effect of dust dirt and type of lamp used
Condition of room and type of lamp used
Which is not found in a rapid start fluorescent lamp?
Ballast
Starter
Wire harness
Capacitor
Prior starting of fluorescent lamp, heating of electrode is done by
Starter
Capacitor
Ballast
Receptacle
A direct lighting fixture directs at least
90% of lighting downward
85% of lighting downward
90% of lighting upward
85% of lighting upward
What is the burning hours that should be used in design consideration of incandescent bulb?
1000
1500
2000
2500
Which of the following affects the overall efficiency of a lighting installation?
Age of the lamp
Dust and dirt
Voltage
All of the above
Life burning hours of a typical 40W fluorescent lamp is
24000
20000
16000
12000
It is the unit of illumination when centimeter is taken as the unit of the length
Lux
Candle
Phot
Fc
{"name":"Illuminations eyyyy", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"1. Polar graph representing variation in candle power of illumination, 2. The illumination is directly proportional to the cosine of the angle made by the normal to the illuminated surface with the direction of the incident flux. The above statement is associated with, 3. It is a quantitative measure of the ability of a light source to reproduce the colors of various objects faithfull in comparison with an ideal or natural light source. Also called color accuracy","img":"https://www.quiz-maker.com/3012/images/ogquiz.png"}