Mock Quiz

A high-quality illustration of a racing car on a track with safety features and automotive components highlighted. Include elements like diagrams of roll bars, sensors, and fire extinguishers in a dynamic and engaging style.

Engaging Automotive Knowledge Quiz

Test your knowledge in automotive regulations and design standards with our engaging mock quiz! Challenge yourself with multiple-choice questions covering crucial topics that every automotive enthusiast should know.

Sharpen your skills and prepare for competitions or academic assessments. Key features include:

Detailed questions
Instant feedback
Educational insights

15 Questions4 MinutesCreated by DrivingGear123

The bodywork in front of the front wheels must have a radius of ______ extending at least 45° relative to the forward direction, along the top, sides and bottom of all affected edges.

At most 10 mm

At least 28 mm

At least 38 mm

At most 45 mm

Documents must be named as :

Team#_TeamName_FBV-DocumentName_Year_V#

Team#_TeamName_FBV-DocumentName_Year

TeamName_FBV-DocumentName_Year_V#

Team#_TeamName_DocumentName_Year_V#

The shutdown circuit directly controls :

All electrical power to the ignition and fuel injectors

All electrical power to the ignition, fuel injectors and all fuel pumps

All electrical power to the ignition and all fuel pumps

Electrical controls to the ignition, fuel injectors and all fuel pumps

Each team must have at least two dry chemical/dry powder fire extinguishers with a minimum firefighting agent capacity of :

0.9 kg

0.5L

1.2L

Each team must have a removable device (called the quick jack) that lifts up the vehicle, so that all driven wheels are ____off the ground and the vehicle is adequately supported

Above the ground

At most 50 mm

At least 50 mm

At least 100 mm

Sensors must not exceed the_____ (measured at the height of the hubs).

front wheel

length of the rear axle

width of the front axle

width of the rear axle

To detect hard braking, the threshold must be chosen such that there are no locked wheels and the brake pressure is :

= 10 bar.

= 30 bar.

� 15 bar.

� 30 bar.

Adjustable tie-rod ends must be constrained with a ____ to prevent loosening.

Jam nut

Washer and nut

Hex nut

Cap nut

Any aerodynamic device must be able to withstand a force of 200 N distributed over a minimum surface of 225 cm2 and not deflect ____ in the load carrying direction

Less than 5 mm

Less than 10 mm

More than 20 mm

More than 10 mm

For Finger guards, Mesh or perforated material may be used but must prevent the passage of a _____ object through the guard

5 mm radius

10 mm diameter

12 mm diameter

12 mm radius

Any portion of the roll bar, roll bar bracing or chassis which might be contacted by the driver's helmet must be covered with a _________ of padding which meets SFI spec 45.1 or FIA 8857-2001.

The tab or bracket to which any harness is attached must have :

Thickness of 1.5 mm

A maximum thickness of 1 mm.

A minimum thickness of 1 mm.

A minimum thickness of 1.6 mm.

TMax is _____ the time of the fastest vehicle including penalties in Skidpad scoring.

1.25 times

1.5 times

25 times

2 times

Mock Quiz

Engaging Automotive Knowledge Quiz

More Quizzes