RULE BOOK TEST
Rule Book Challenge
Test your knowledge and understanding of the essential rules and regulations in racing engineering with our Rule Book Challenge. This quiz covers various technical specifications and requirements that every team must be aware of to ensure safety and compliance.
Prepare to answer questions related to components, systems, and guidelines in engineering design:
- Suspension and steering components
- Braking systems performance
- Sensor positions and specifications
- Structural integrity and more!
All moving suspension and steering components and other sharp edges inside the cockpit between the front hoop and a vertical plane ______ cm rearward of the pedals, must be shielded with solid material.
10
100
20
15
In the case of a leak or failure at any point in the system, effective braking power is maintained on at least _______ wheels.
4
2
1
Both A and B
The action of opening the shutdown circuit must occur if the implausibility is persistent for more than 500 ms.
True
False
Incorrect templates results in
Considered as non-submission
Deduction of 10 pts
DR
Deduction of 5 pts
The directly connected vacuum devices are accepted in catch can and exhaust system.
True
False
Not mentioned
Prior to the tilt test , engines fitted with mechanically actuated fuel pumps must be run to fill and pressure the system ________ of the high pressure pump.
Down stream
Up stream
Along the flow
Both A and C
Which circuit is preferred for bspd
Standalone non-programmable circuit
System critical signals
Standalone programmable circuit
Both A and B
Sensors may be mounted with a maximum distance of _____ mm above the ground and less than ______ mm forward of the front of the front tires
750,500
700 , 500
500, 700
500, 750
There must be at _______ between the edge of the numbers and the edge of the background.
At most 25 mm
At least 25mm
More than 25 mm
25mm
The following elements must be expanded on as a part of the pitch deck
Company Vision / Mission
Market Research
Exit Strategy
None of these
Time allotted In Engineering Design Q&A session for Judges’ clarifications and queries time is
1200 sec
900 sec
1500 sec
600 sec
If two parts of the primary structure are bolted together, each attachment point between the two parts must be able to carry a load of ______
40 KN
30 kN in same direction
30 kN in any direction
Which of the following statement for IA is False
Attached securely and directly to the AIP
Installed forward of the front bulkhead
At least 100 mm high and 200 mm wide for a minimum distance of 100 mm forward of the front bulkhead.
Cannot be wider or higher than the AIP
TSAC stands for
Tractive System Accumulator Container
Tractive System Active Container
Traction System Accumulator constant
Tractive signal Accumulator Container
{"name":"RULE BOOK TEST", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"Test your knowledge and understanding of the essential rules and regulations in racing engineering with our Rule Book Challenge. This quiz covers various technical specifications and requirements that every team must be aware of to ensure safety and compliance.Prepare to answer questions related to components, systems, and guidelines in engineering design:Suspension and steering componentsBraking systems performanceSensor positions and specificationsStructural integrity and more!","img":"https:/images/course8.png"}
More Surveys
PSSR question summary
7430
Master Your Local Anesthesia Knowledge
502526
Transformer Basics Survey
10515
LLSS Rules
420
Bu 2 transportation systems (parts of escalator not included)
52260
Deuce Four Barracks Leader's Checks
10532
WHS Housekeeping
6329
Wollam, Scherrer, Deane, Fischer, Nesbit Deane, Deane McKenna Family Reunion
940