Automotive Safety Standards Quiz

Create an image of a modern automotive workshop with engineers discussing safety standards, surrounded by various car parts and safety equipment, in a bright and organized environment.

Automotive Safety Standards Quiz

Test your knowledge of automotive safety standards with this comprehensive quiz. Designed for engineers, students, and enthusiasts alike, this quiz covers critical topics related to vehicle design, safety regulations, and engineering best practices.

Assess your understanding of safety protocols
Challenge yourself with multiple-choice questions
Gain insights into automotive standards and regulations

15 Questions4 MinutesCreated by SafetyCheck247

For sleeved joints the sleeve must have a minimum length of _______ either side of the joint and be a close-fit around the base tubes

.36m

.036m

0.038m

If the attachment point of the upper member is _____________ above the upper side impact member, node-to-node triangulated bracing is required to transfer load to the main hoop.

>0.001m

<100 mm

>15cm

<0.015m

If (IA) is welded to the front bulkhead, it must extend ____________ to the centerline of the front bulkhead tubing in all directions

Equal

At least

At most

None of the above

Seated in a normal driving position, the driver must have a ________ field of vision of ___

Minimum, 100 deg

Maximum, 100 deg

Minimum, 200 deg

Maximum, 200 deg

Each hydraulic circuit must have its own fluid reserve, either by the use of separate reservoirs or by the use of a __________ reservoir

Dammed

Tandem

Simple

Both a and b

Which Prevailing torque lock nuts are accepted as positive locking mechanisms

ISO 7042

ISO 7040

ISO 7050

ISO 7045

Full form of AFFF

Aqueous friction foaming foam

Additive film forming form

Aqueous film forming foam

Additive film foaming form

Lines must be rigidly connected every ________ by mechanical fasteners to structural engine components.

50mm

75mm

100mm

110mm

After technical inspection, which of the following modifications is restricted to the vehicle?

Software calibration changes

Replacement of defective brake pads

Both a and b

None of the above

If analog sensors are used, they must have different, ___________________.

Intersecting receiver functions

Non-intersecting transfer functions

Intersecting transfer functions

Non-intersecting receiver functions

When power is removed, the electronic throttle must immediately close at least to idle position ______________

±5%

±10%

±15%

±20%

Which of the following is false statement regarding steering wheel

Near circular

Continuous perimeter

Include concave section

250mm rearward of front hoop

Automotive Safety Standards Quiz

Automotive Safety Standards Quiz

More Quizzes