Rulesquiz_20171221_01
Your brake pads are worn out after the autocross. For the endurance you change to pads with a harder compound. Which statement is true?
You have to perform and pass the brake test again
It is allowed, if you show the worn brake pads before changing to a mechanical scrutineer
After changing the brake pads you have to let a scrutineer check the brake caliper fasteners
This is allowed
This is not allowed
The event site, including the FSC and FSE pits, will be closed during the night between midnight and 06:00 am for safety reasons. Which statement is true?
Teams are allowed to move the car without any consequences to the camp site before closure time
Teams that remove their car from the event site after the event begun will be disqualified from the FSG event
The pits will be closed between midnight and 06:00 am, but a team can apply for an exception with a wild card
The pits will be closed between midnight and 06:00 am, except the night before the endurance
Cars can be removed from the event site and brought back after a re-scrutineering
What is the correct order of the Skid-Pad laps?
Left, right, right, left
Right, right, left, left
Left, right, left, right
Left, left, right, right
Right, left, right, left
What alcohol permittage is allowed at the event site until Sunday evening?
Team Members: 0.2‰; Drivers: 0.2‰
Team Members: 0.0‰; Drivers: 0.0‰
Team Members: 0.2‰; Drivers: 0.0‰
Team Members: 0.5‰; Drivers: 0.2‰
Team Members: 0.5‰; Drivers: 0.0‰
What is the maximum allowed length of a straight part in an endurance track?
242.4 feet
75 m
77 m
60 m
80 m
What is the maximum amount of points a team can reveive in the design event if it enters the design event with an unfinished car?
100 points
150 points
80 points
60 points
0 points
For all changes made after the submission of the Cost Report a cost addendum is mandatory, which statement is true?
The cost addendum must be provided during registration as hardcopy to the FSG Officials at Event Control
The cost addendum must be submitted via the FSG website and drawings must be presented during the cost event as hardcopy
The cost addendum and drawings must be provided to the judges at the beginning of the cost event
The cost addendum and drawings must be provided to the statics counter at the beginning of the cost event
The cost addendum and drawings must be uploaded as pdf-file at the FSG website in the "My Team" area
An addendum is not possible
Which statement on the preparation is true if the team is about to present its car for M-Scrutineering?
Enter M-Scrutineering with the smallest driver in the car, rain tires mounted on and bring 6 team members with you for possible improvement and repairs
Enter M-Scrutineering wiht the tallest driver in the car, present all tyres (on rims) you plan to use at the event and be prepared for the driver harness system check
Enter M-Scrutineering with the tallest driver in the car in ready-to-race condition and be prepared for roll bar height and egress check
Enter M-Scrutineering with the tallest driver in the car and have a copy of the cost and design report with you
Enter M-Scrutineering with the tallest driver in the car, take the Tractive System Accumulator Container Hand Cart with you and show the two required fire extinguishers to the security at the dynamic gate
What is the theoretical maximum bending of a round tube with the dimensions of 25x2.5mm and a total length of L = 495mm, when both ends lie freely on a support and two 26kN point loads are acting exactly 114.5 mm to the left and right from the middle of the tube's longitudinal axis (E=210000 MPA)
40.3 mm
2.01 mm
4.03 mm
403 mm
0.403 mm
4030 mm
What tube is not possible as alternative for a baseline steel 25.4x1.60 mm round tube, if you want to use it for your Side impact structure? NOTE: round to whole numbers!
26x1.5mm
27x1.3mm
28x1.2mm
25x1.8mm
27.4x1.2
24.3x2mm
To which angle would you have to tilt a car so that the direction of gravity is colinear with the forces experienced during a lateral acceleration of 1.41g on track
30.0°
27.3°
54.7°
60°
35.3°
51.3°
What kind of post-processing is allowed to remove acceleration spikes from the IAD?
3rd Order 100Hz lowpass
Class 60 filter (SAE-J211)
10ms FIR Filter (ISO-19575)
Having no tire defects and dry track conditions, how many dry tires are you allowed to use during all of the dynamic events at FSG?
8
Any multiple of 4
4
As many as I want, as long as they are presented at scrutineering and of the same type/compound
{"name":"Rulesquiz_20171221_01", "url":"https://www.quiz-maker.com/QPREVIEW","txt":"Your brake pads are worn out after the autocross. For the endurance you change to pads with a harder compound. Which statement is true?, The event site, including the FSC and FSE pits, will be closed during the night between midnight and 06:00 am for safety reasons. Which statement is true?, What is the correct order of the Skid-Pad laps?","img":"https://cdn.poll-maker.com/24-932537/durchbiegung.png?sz=1200-00000000301000005300"}
More Surveys
Make your own Survey
- it's free to start.
- it's free to start.